Garage Door Opener Guide
LiftMaster 98022 Review & Installation Guide
The LiftMaster 98022 is a DC belt-drive opener with built-in myQ Wi-Fi, battery backup, and a camera. Here is everything Surrey homeowners need to know before buying or having one installed.
What Is the LiftMaster 98022?
The LiftMaster 98022 is a premium residential garage door opener in LiftMaster's Elite Series. It uses a DC belt drive for near-silent operation, includes a built-in 1080p camera with two-way audio, and connects to the myQ smart-home platform via built-in Wi-Fi — no separate hub required. It also includes a battery backup that keeps the door operational during power outages. Surrey Doors Ltd. installs and services the 98022 throughout Surrey, including South Surrey, White Rock, and the surrounding Lower Mainland.
LiftMaster 98022 — Pros and Cons
Pros
- Near-silent belt drive — ideal for attached garages and bedrooms above the garage
- Built-in myQ Wi-Fi eliminates the need for a separate smart-home hub
- 1080p camera with two-way audio provides real-time garage monitoring
- Battery backup keeps the door working during BC Hydro outages
- Lifetime motor and belt warranty — the best in the residential opener category
- Compatible with Amazon Key for in-garage delivery
Cons
- Higher upfront cost than chain-drive alternatives
- myQ subscription required for some advanced features (package detection, delivery alerts)
- Camera requires a 2.4 GHz or 5 GHz Wi-Fi network within range of the garage
- Requires professional installation to maintain warranty — not a DIY unit
LiftMaster 98022 Installation in Surrey
The 98022 requires professional installation to maintain the LiftMaster warranty and to ensure the door is properly balanced before the opener is connected. An unbalanced door will overwork the motor and shorten its service life. Surrey Doors Ltd. installs the 98022 as a complete package: we inspect and balance the door, install the opener and rail, connect the myQ app, and test all safety features before leaving.
Door balance check
Before any opener is installed, we disconnect the existing opener and manually test the door balance. A door that does not stay in place at mid-travel has a spring or cable issue that must be resolved first.
Rail and header bracket installation
The T-rail is assembled and mounted to the header bracket above the door. Correct header bracket height is critical — too low and the door will bind; too high and the opener will not have enough travel.
Motor unit mounting
The motor unit is hung from the ceiling with the supplied straps and connected to the rail. We confirm the unit is level and the trolley moves freely.
Door arm connection
The curved and straight door arms are connected between the trolley and the door bracket. Arm geometry is adjusted so the door does not bind at the top of travel.
Limit and force calibration
Open and close limits are set so the door fully opens and closes without over-travel. Up and down force settings are calibrated to the door weight.
Safety reversal test
We place a 2x4 flat on the floor and close the door. The door must reverse on contact. We also test the photo-eye beam interruption reversal.
myQ app setup
We connect the opener to your home Wi-Fi network and walk you through the myQ app setup on your phone, including notification preferences and access sharing.
Setting Up myQ on the LiftMaster 98022
The 98022 has built-in Wi-Fi — there is no separate myQ hub to purchase. Setup takes about five minutes.
Download the myQ app
Available free on iOS and Android. Create a myQ account or sign in if you already have one.
Add a device
Tap the + icon in the app and select Garage Door Opener. The app will search for the opener via Bluetooth during initial pairing.
Connect to Wi-Fi
Enter your home Wi-Fi password when prompted. The opener supports both 2.4 GHz and 5 GHz networks.
Name the device
Give the opener a name (e.g. Main Garage) so it is easy to identify if you have multiple doors.
Set notifications
Enable open/close alerts and set a closing reminder if you want the app to notify you when the door has been open for a set period.
If the opener loses its Wi-Fi connection after a router change, hold the Wi-Fi button on the motor unit for 10 seconds to reset the network settings and repeat the pairing process.
Compatibility checked: October 2026. myQ smartphone control is built into the 98022. Third-party platform integrations change over time — verify current support at myq.com/partners before purchase. View current myQ partner integrations →
LiftMaster 98022 Troubleshooting
Opener runs but door does not move
Likely cause: Trolley is in manual release mode (red cord pulled)
Fix: Re-engage the trolley by pulling the red cord toward the motor unit until it clicks, then operate the door with the remote.
Door reverses immediately after closing
Likely cause: Photo-eye misalignment or obstruction
Fix: Check that both photo-eye lenses are clean and aligned — the indicator light on the receiving eye should be solid, not blinking. Clear any obstruction in the beam path.
myQ app shows opener as offline
Likely cause: Wi-Fi signal too weak at the opener or router change
Fix: Check Wi-Fi signal strength at the opener location. If signal is weak, add a Wi-Fi extender. If the router was changed, reset the opener Wi-Fi and re-pair.
Remote works from close range only
Likely cause: Antenna wire not hanging down or logic board antenna fault
Fix: Confirm the antenna wire hanging from the motor unit is fully extended and not coiled. If the issue persists, the logic board may need replacement.
Battery backup light is red or flashing
Likely cause: Battery is low or has failed
Fix: The backup battery is a sealed lead-acid unit inside the motor housing. It typically lasts 3–5 years. Replace with a LiftMaster 485LM battery.
Camera image is blurry or not loading in myQ
Likely cause: Wi-Fi bandwidth issue or camera firmware needs update
Fix: Check that the myQ app is up to date. In the app, go to device settings and check for a firmware update. If the image is blurry, clean the camera lens with a soft cloth.
LiftMaster 98022 Installation Cost in Surrey
Prices current as of October 2026. Final quote provided after on-site assessment.
LiftMaster 98022 vs. Chamberlain RJO101 vs. Genie 6172
The 98022 competes directly with the Chamberlain RJO101 (wall-mount) and the Genie 6172 (screw-drive). The 98022 is the best choice for homeowners who want a ceiling-mount belt-drive opener with a built-in camera and the longest warranty available. The RJO101 is better suited to garages with low headroom or cathedral ceilings where a ceiling-mount rail is not practical. The Genie 6172 is a strong mid-range option for homeowners who want smart-home connectivity at a lower price point.
| Feature | LiftMaster 98022 | Chamberlain RJO101 | Genie 6172 |
|---|---|---|---|
| Drive type | Belt | Wall-mount (jackshaft) | Belt |
| Built-in camera | Yes (1080p) | No | No |
| Battery backup | Included | Included | Optional add-on |
| Smart home | myQ built-in (see myq.com/partners) | myQ built-in (see myq.com/partners) | Aladdin Connect built-in (verify Canadian integrations) |
| Motor warranty | Lifetime | Lifetime | Lifetime |
| Low headroom compatible | No | Yes | No |
| Installed price (Surrey) | C$620–C$780 | C$680–C$860 | C$480–C$620 |
LiftMaster 98022 FAQs
Yes, with the optional extension kit. The standard rail covers 7-ft doors. The extension kit adds the length needed for 8-ft doors and is available from Surrey Doors Ltd. for C$45–C$65.
Basic open/close control and notifications are free. The myQ Premium subscription (approximately C$4/month) adds package detection, delivery alerts, and integration with Amazon Key for in-garage delivery.
LiftMaster states the backup battery provides approximately 50 open/close cycles after a full charge. In practice, this is more than enough for a typical BC Hydro outage.
LiftMaster recommends professional installation to maintain the warranty. More importantly, the door must be properly balanced before the opener is connected — an unbalanced door will damage the motor. Surrey Doors Ltd. includes a door balance check with every opener installation.
The 98022 includes a built-in 1080p camera and battery backup as standard. The 87504 is a belt-drive opener without a camera. If you do not need the camera, the 87504 is a lower-cost alternative with the same drive system and myQ connectivity.
Yes. We install and service the 98022 throughout Surrey, including South Surrey, White Rock, Elgin Chantrell, Morgan Crossing, and Grandview Heights.
Ready to Install the LiftMaster 98022 in Your Surrey Home?
Call Surrey Doors Ltd. for a same-day quote. We supply and install the 98022 throughout Surrey and the Lower Mainland.